Start-up capacitor CD60, 450V, 150uF

The CD60 type starting capacitor is designed for starting single-phase AC motors. It is used as a short-term loaded capacitor to create a phase shift and increase the starting torque, typically in compressors, pumps and fans. The design in a plastic housing with terminals allows for easy connection to the starting circuit.

Technical specifications

• Type: CD60 (starting capacitor)
• Capacitance: 150 µF
• Rated voltage: 450 V AC
• Frequency: 50/60Hz
• Construction: electrolytic capacitor in plastic case
• Connection: wires with molded fork connectors

Functions and features

• Designed for short-term starting operation in the engine starting circuit
• Creates phase shift for auxiliary winding and supports higher starting torque
• Suitable for use with a starter relay or centrifugal switch
• Plastic case for basic mechanical protection

Ideal for

• Single-phase asynchronous motors with starting capacitor
• Compressors and refrigeration technology
• Pumps, fans and smaller machines with starting circuit
• Service replacement of starting capacitors in motor applications

Package contents

• 1 pc of starting capacitor CD60 150 µF 450 V AC

Why choose this product?

• Clearly defined electrical parameters for starting applications (150 µF, 450 V AC)
• CD60 version designed for engine starting
• Practical connection using wires with connectors for quick assembly

Installation and operating instructions

• Before replacing, verify the required capacity and voltage rating according to the device label and wiring diagram.
• Use the CD60 start capacitor only in a starting circuit with disconnection after starting (relay/switch)
• Always safely discharge the capacitor using the appropriate procedure before handling.

Safety notice

• The product is intended for mains voltage circuits and can operate with dangerous voltages of 230 V AC and higher.
• Perform installation only with the power supply disconnected and in compliance with the principles of working on electrical equipment.
• Do not use as a permanently connected run capacitor unless the application specifically requires it.