Voltage converter from 12V DC to 24V DC, 20A, 480W, IP67

The DC/DC voltage converter is designed to increase direct current voltage from 12 V to 24 V at an output current of 20 A. It serves to power devices requiring a 24V DC power supply from a 12V DC source, for example in island, battery, vehicle, or technical power systems.

Technical specifications

• Device type: DC/DC voltage converter
• Input voltage: 12 V DC
• Output voltage: 24 V DC
• Output current: 20 A
• Output power: 480W
• Dimensions: 140 x 120 x 42.5 mm
• Protection: IP67

Functions and features

• Increases direct current voltage from 12 V DC to 24 V DC.
• Designed for powering 24V DC devices from a 12 V DC voltage source.
• Suitable for systems where it is necessary to separately solve proper fusing, wire sizing, and cooling according to the load.
• The design of the converter requires correct connection of input and output polarity.

Ideal for

• Power systems with an input voltage of 12 V DC and a requirement for a 24 V DC output.
• Automotive, service, and technical installations with direct current power supply.
• Battery and island power systems.
• Devices and electronics designed for 24V DC power supply.

Package contents

• DC/DC voltage converter 12 V to 24 V, 20 A

Installation and operation instructions

• Mounting and connection must be performed by a person with appropriate professional qualification.
• Before connection, verify the match of the input voltage of the source and the required output voltage of the load.
• Observe the correct polarity of the input and output.
• Use wires and fusing corresponding to the current load.
• Install the converter in a place with sufficient heat dissipation.
• Do not exceed the specified output parameters.

Safety warnings

• Incorrect connection can cause a short circuit, overheating, damage to the converter, or damage to the connected device.
• The device operates with higher currents, therefore it is necessary to ensure an adequate wire cross-section and suitable fusing.
• Always disconnect the power supply before mounting and maintenance.
• Do not cover the converter during operation and do not place it in an area without the possibility of heat dissipation.
• Do not use the converter in an installation where the requirements for voltage, current, and safe connection are not met.

Why choose this product

• Allows powering 24V DC devices from a 12V DC source.
• The parameters of 12 V DC on the input and 24 V DC / 20 A on the output correspond to use in direct current power systems.
• The dimensions of 140 x 120 x 42.5 mm allow integration into technical assemblies with limited mounting space.
• Suitable as a part of installations where a change in the level of direct current voltage is required.